Engine Question
« previous next »
Pages: [1]

Author Topic: Engine Question  (Read 2860 times)

0 Members and 1 Guest are viewing this topic.

Offline Kilo42

  • Newbie
  • *
  • Posts: 47
    • View Profile
Engine Question
« on: August 31, 2005, 03:09:06 PM »
I recently installed a K&N replacement filter on my Elllison TBI.  Now when I go full rich and full throttle my engine runs rough.  I have to lean my engine to get it to run smoothly.  

What would cause this to happen.  I have not changed my air inlet configuration, just the filter.  

I have also installed a new catto 3 blade, would that effect it in any way?


Thanks

Kilo42
Logged

Offline Barney

  • Newbie
  • *
  • Posts: 46
    • View Profile
    • http://www.negotiationscoach.com
Engine Question
« Reply #1 on: August 31, 2005, 06:14:02 PM »
How about removing the new K&N filter, and trying Full Rich/FullThrottle?  If it runs sweetly, maybe your filter is acting like a "choke" and enriching your mixture too much.  If that's the case maybe a less restrictive filter is in order.
Logged

Offline spy

  • Newbie
  • *
  • Posts: 37
    • View Profile
engine
« Reply #2 on: August 31, 2005, 06:52:47 PM »
hello,
  you will need to adjust the needle of the ellison.,,,,another thing is after full "open throttle"..back it up just a little until it smooths out..an use that as your full open...egts have to be 100-120 diffrnce full rich to full lean.
Logged
Pages: [1]
« previous next »