If you have the option, using a 24-foot-box truck with a liftgate will accomodate an Eze nicely. The fuselage is rolled onto the liftgate with the tail-end facing forward, and with someone holding the nose (gear retracted), the lift gate is raised. Best to chock the wheels on the gate with 2x4's and clamps. Roll the airplane into the truck. Chock the wheels, and secure the nose with straps wrapped around the upper section of the F-22 bulkhead, and secured on each side of the sidewall of the truck. Make sure you pad the prop hub (take the spinner off, if so-equipped) with a folded up moving blanket. Put a pad under the nose as well.
The canard can be wrapped well with moving blankets and secured hanging from one side of the wall.
Wrap the wings and lay them flat, with the winglets on either side of the nose, and secure via the tie-down holes, and with soft nylon rope through the wing fittings. This arrangement will travel well for over 1000 miles. Been there, done it.
Transport in such a truck eliminates all potential for roadrash, rock dings, etc. If only going a short distance, the trailer is fine, but at 50 MPH, I believe the chance for rash & FOD damage is fair. Structurally, the winglets will be fine in all wind factors. The winglets are built to withstand something on the order of a full 90-degree sideslip at the 180 knot level, as I recall.
Good transporting,
-Joe Person
VariEze N79JN
EAA Tech Counselor 4418
Bothell, WA (KPAE)