1
For Sale/Wanted / Engine mount for sale
« on: August 20, 2017, 09:38:39 PM »
Lycoming type 2 Cozy III Engine mount for sale. $450.00
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
For Sale/Wanted / Longez nose wheel
« on: July 12, 2014, 07:03:23 AM »
Found during the condition inspection mine is damaged.
3
Hangar Flying / Posting
« on: July 03, 2014, 04:08:07 PM »
I'm trying to post a small picture and it says the upload folder is full! What's up with that?
4
Hangar Flying / Roncz canard elevator balance
« on: May 15, 2013, 06:31:52 PM »
Weight is good for the elevators at 3.3 and 3.7. Balance is leading edge down. Since the weight is good should I take some off the balance weights and try to get closer to a perfect balance or is nose down good?
5
For Sale/Wanted / Smart Coupler II
« on: April 26, 2013, 01:57:14 PM »
Need a Smart Coupler, mine seems to have failed 
Thought someone might have one laying around after removing their Navaid Autopilot.
Thought someone might have one laying around after removing their Navaid Autopilot.
6
Hangar Flying / EZ ride
« on: December 08, 2012, 12:39:22 PM »
I live in Tucson and am looking for a back seat ride to get familiar with the Longez or Varieze. I am purchasing a Varieze and would like to buy fuel for a backseat ck.
7
Hangar Flying / Longez Gear Leg Fairings for Sale
« on: December 19, 2011, 07:18:40 PM »
I have a set of unused Light Speed Longez gear leg fairings for sale. $500.00
8
Hangar Flying / Wright Nose Lift
« on: December 27, 2008, 10:01:10 AM »
What size circuit breaker should be installed. It is not indicated on the drawings that came with the nose lift kit.
Thanks
Thanks
9
Hangar Flying / NACA Scoop
« on: July 30, 2007, 10:33:13 PM »
Is the NACA Scoop notched into the bottom of the fuselage and firewall or does it just lay on top?
10
Hangar Flying / Oil Heat
« on: February 23, 2007, 05:42:24 PM »
I am planning on oil heat for the Longez. I plan to put the oil cooler in the hell hole. Does anyone have an idea for a blower motor, besides Waiter's 1982 rabbit blower motor. Waiter's 10 amp circuit braker seems a bit much for this installation. I'm looking for a motor that will be do the job,but with minimum power requirements.
11
Hangar Flying / Waiter
« on: February 25, 2006, 06:38:50 PM »
Website has not been updated for some time, have you stopped working on the project? 
12
Hangar Flying / X-Plane V8
« on: December 03, 2005, 09:02:19 AM »
Is there a Longez for X-Pane V8?
13
Hangar Flying / Gas Caps
« on: October 03, 2005, 07:02:51 PM »
I am getting ready to install the Gas Caps in my Longez project. Has someone had a recent experience and have a recommendation for a good solution?
Pages: [1]