Show Posts - atfloyd

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - atfloyd

Pages: 1 [2]
16
For Sale/Wanted / wanted nose gear
« on: May 17, 2007, 12:08:22 PM »
Looking for a nose gear assembly for a long ez

17
Hangar Flying / Forward hatch latch/release
« on: May 08, 2007, 06:34:27 PM »
Hey folks...I have built an extended nose with "C" type hinges for the forward hatch.  I need to see if anyone has a latch design or ideas to that effect for the forward hatch.  I need a design that will release from the side via a cable inside the fues.  I have seen them out there but can't seem to track one down.  Any help would be appreciated.  Thanks


Allen
milehighlongez.com

18
Hangar Flying / Battery
« on: April 23, 2007, 02:38:39 PM »
Any recommendations for a battery to use in an extended nose EZ.

19
Hangar Flying / Forward hatch latch
« on: February 18, 2007, 03:46:40 PM »
For those of you who have installed thier forward hatches with the C/J hing mod.  I am looking for a good latch that you can use from the cockpit via a cable.  Any input, plans or ideas?  Thanks

Allen

20
Hangar Flying / Electric roll trim
« on: March 17, 2006, 11:09:29 AM »
Anyone have any luck with a Ray Allen servo in thier roll tim setup?  I am looking for alternatives to the plans trim system.  Thanks

Allen

21
Hangar Flying / ENGINE OVERHAUL
« on: March 11, 2006, 07:10:27 AM »
I need a recommendation for a good engine overhaul shop.  It is time to mount my engine, so I need to get it ready. Thanks

22
Hangar Flying / CS 132 bellhorns
« on: March 05, 2006, 09:59:44 AM »
With Brock no longer selling parts and Spruce somewhere in limbo, does anyone have a lead on a set of CS132 bellhorns?  Thanks

23
Hangar Flying / rotary power
« on: February 24, 2006, 10:51:13 PM »
Hi folks, I am doing some research on a rotary motor for my Long Ez.  anyone have any experience in this mod. Any input would be great..
Thanks...

24
Hangar Flying / Century Springs for hidden rudder bellcrank mod
« on: February 10, 2006, 09:39:58 PM »
Any one have a set of century springs Part#1887 for the hidden rudder bellcrank mod.  I tried to order a set from Century but they have a $30 minimum order.  Kind of steep for 2 spring.  If any one else needs them I can place an order for 14 springs and that should cover the spread.

Allen

25
Hangar Flying / wright nose lift electrical schematic
« on: February 09, 2006, 12:37:27 PM »
Hi, Thanks for the response.  I did get intouch with Steve and he got me all set up.  
Thanks again.

 Allen

26
Hangar Flying / wright nose lift electrical schematic
« on: January 18, 2006, 09:30:29 AM »
I have installed my nose lift but do not have the electrical schematic.  I tried to get in touch with Steve but no luck.  Any one have a set that I might gander at?  I appreciate any assistance.  

Allen 8)

27
Hangar Flying / Wright nose lift plans
« on: January 15, 2006, 08:48:36 PM »
I have bought a Wright nose lift and did not get any plans.  Does anyone have a set that I might get a copy of.  I need to find the measurements for the hole in bulkhead for the actuator to stick through..

Thanks

Allen

28
Hangar Flying / Space saver electrical panel
« on: December 26, 2005, 07:10:50 PM »
I am looking for a space saver electrical panel for my LEZ project.  I have seen them on some EZ's but don't know where to find one.  Any help would be great. Thanks

Allen

Pages: 1 [2]