Hangar Flying

Hangar Flying => Hangar Flying => Topic started by: atfloyd on March 17, 2006, 11:09:29 AM

Title: Electric roll trim
Post by: atfloyd on March 17, 2006, 11:09:29 AM

Anyone have any luck with a Ray Allen servo in thier roll tim setup?  I am looking for alternatives to the plans trim system.  Thanks

Allen

Title: Electric roll trim
Post by: EZPILOT742X on March 17, 2006, 02:51:49 PM

Hello,
Check this out on James Redmon's Berkut site.:

http://www.berkut13.com/berkut29.htm#aileron

This is a pretty typical Ray Allen/electric trim installation on an EZ-type aircraft. On my Berk-EZ I'm planning on mounting the servo in a similar fashion but using the "Wright/Hanka" spring set up. You can see a description of that on Wayne Hick's Cozy site here:

http://www.maddyhome.com/canardpages/pages/waynehicks/chapter_17_1.htm

Hope that helps,
Chris Randall
Berk-EZ N742X

Title: Installed
Post by: Hiflier68 on March 20, 2006, 12:54:26 AM

I have just finished an install of the Hanka spring. Send me an email address and I can send them over.

Mitch  hiflier68@yahoo.com
N60P
Tampa