Show Posts - 16FW

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 16FW

Pages: [1]
1
Hangar Flying / Re: Paint stripping
« on: May 17, 2010, 06:08:11 AM »
I had arranged for a soda blast guy to come this past weekend to give me an estimate, but he never showed up.

2
Hangar Flying / Re: Paint stripping
« on: May 14, 2010, 11:30:55 AM »
I'm sure you already know, but I gotta mention - any stripper or mixture you consider using should be checked to see if it is possible for it to harm the foam.  If there's a way, it will find its' way to the foam and could melt it.

Good luck.
Yep I know, but I hadn't thought about that issue. Thanks!

3
Hangar Flying / Paint stripping
« on: May 14, 2010, 08:47:53 AM »
Is there a way to strip just the topcoat and leave the primer? I used Blue River water-borne urethane, and it is cracking, ad flaking off. The primer is fine, and showing through in a lot of places. It was a lot of work to fill/sand/fill/prime, as most of you know, and I would hate to do all of that again.

My primer was US paints, and their rep at Oshkosh said their AwlGrip primer is pretty tough, and I could probably find a concoction of chemicals to wash the Blue River junk off. He just didn't say what mixture  ::)

I have been looking at some of the newer, milder, chemical strippers, but none say they can only take off one layer of paint. I have also looked at soda blasting, but i get the idea that it would also take off all the paint.

If it matters, my plane is a Rutan Defiant (hi Harry)

Pages: [1]