Show Posts - Kevin Clay

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Kevin Clay

Pages: [1]
1
Hangar Flying / UV blocking primer
« on: September 17, 2011, 08:48:43 AM »
Hi Everyone,

I've got some bubbles and peeling in the Imron finish of my Varieze. I can't face the task of stripping and refinishing the whole plane right now, so I'm going to have to do spot repairs.  My main question is what UV blocking primer I can use that's available in quart sizes.  I've been looking for Dupont 131S but can't find it in a quart size (I just don't need a whole gallon).  The alternative that Spruce sells is waterborn and not recommended for wet sanding, which I'll want to do.  Anyone know what I can use under Imron?  Also, any advice on spot repairs to the finish would be welcome.

Thanks,

Kevin Clay 

2
Hangar Flying / Varieze Fuel Vent
« on: February 16, 2008, 04:13:18 PM »
Thanks for the feedback.  Since it an O-200 with ram air into the carb, it sounds like I'd better keep it as is to get ram air into the vent.  Maybe I'll make it more like a fin pitot to get it out of the boundary layer but reduce the drag a bit.

3
Hangar Flying / Varieze Fuel Vent
« on: February 16, 2008, 10:46:33 AM »
I've got this ugly and draggy fuel vent on my Varieze, and I'm finally going to redo it.  Any advice?  I need to make sure it does not end up inadvertently creating negative pressure, but I want to minimize it as much as I can.

Thanks for any recommendations or pictures of proven vents.

4
Hangar Flying / Looking for life insurance
« on: April 14, 2006, 10:48:13 AM »
Check with EAA.  It's in the member benefits section of the website.

5
Hangar Flying / WAF
« on: April 03, 2006, 08:13:06 PM »
You should be able to get them from Aircraft Spruce, if not your local aircraft supply.  I was also told that you can use Grade 8 automotive bolts.

6
Hangar Flying / Gear leg fairing angle
« on: April 02, 2006, 04:09:55 PM »
I'm getting ready build go fast fairings on the gear legs of my Varieze, but forgot to measure the pitch angle of the longeron during cruise flight.  Now it's taken apart off airport and it's a little inconvenient to go fly it.  Can anyone tell me what the typical pitch angle a varieze has at around 200 mph?

7
Hangar Flying / Trailering an EZ
« on: January 28, 2006, 10:21:05 PM »
Thanks for the advice.  Actually, I'm bringing it home for a few months to spend some some quality time with it in the garage.  I've got a few projects on it I've been trying to get to for a few years, and now's the time.  I'll probably end up going with the enclosed truck,  but if that's too expensive, I may use a flatbed trailer and wrap it up well to protect it.  In any case I was planning to knock together some padded cradles to hold the wings and canard.  Any ideas?

Kevin N37S

8
Hangar Flying / Trailering an EZ
« on: January 28, 2006, 11:35:02 AM »
I'm planning to trailer my Varieze, and I'll have to go on the highway at least 50 mph.  Should I be concerned about side wind loads on the winglets, since the wings will be secured lengthwise on the trailer?  Also, any suggestions for how to arrange the wings and canard on a flatbed trailer?  - Thanks

Pages: [1]