1
Hangar Flying / Vari-eze Wing Template Drawings
« on: December 29, 2016, 10:23:15 AM »
Looking for Vari-eze wing template drawings in either JPEG, PDF or DWF format.
Anybody have these?
Anybody have these?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Hangar Flying / Anyone following this?
« on: May 16, 2016, 07:31:12 AM »
I've been watching the progress on the Raptor (www.Raptor-Aircraft.com)
Check out the blog entries.
Last September they were talking about the building they had acquired to start the project.
Last week they had the lower fuselage done and had the pressure bulkheads in place.
I was pretty skeptical at first glance but they are serious about this and appear to have the funding to bring it to market.
Check out the blog entries.
Last September they were talking about the building they had acquired to start the project.
Last week they had the lower fuselage done and had the pressure bulkheads in place.
I was pretty skeptical at first glance but they are serious about this and appear to have the funding to bring it to market.
3
Hangar Flying / New Canard Design - Oshkosh 2016
« on: May 06, 2016, 09:14:18 AM »
I was offered a spot on the team that is doing the Vacuum Infusion demo this year at Oshkosh. Talk about a learning opportunity!!!
It will be a new canard design that should prove to be a screamer.
All of the components will be fabricated onsite over the course of four days (Tues.-Fri.)
This will be located in the big tent next to the Warbird Replica building.
It’s not often that we get to see the birth of a new Canard design/kit.
It will be a new canard design that should prove to be a screamer.
All of the components will be fabricated onsite over the course of four days (Tues.-Fri.)
This will be located in the big tent next to the Warbird Replica building.
It’s not often that we get to see the birth of a new Canard design/kit.
Pages: [1]