aileron control rod
« previous next »
Pages: [1]

Author Topic: aileron control rod  (Read 4043 times)

0 Members and 1 Guest are viewing this topic.

Offline robert mencl

  • Newbie
  • *
  • Posts: 9
    • View Profile
aileron control rod
« on: March 19, 2008, 10:05:03 PM »
I would like to buy a good aileron control rod with it's heim ends for the right side of my Long EZ. (The short one, from bellcrank in the wing into the cowl) Also, could any reader please confirm the nominal center to center dimension of same. Thanks, Bob Mencl
Logged

Offline GlennBob

  • Newbie
  • *
  • Posts: 261
  • Eph 2 : 8 & 9
    • View Profile
Aileron control rod
« Reply #1 on: March 20, 2008, 11:43:46 PM »
I read somewhere in the CP's that the heim connectors were supposed to be replaced with larger ones.  Instead of AN 3, . .they were to be AN 4's now.  Izzat true ?  Is everyone doin' it ?   Is it neccessary ?

Glennbob
Logged
N600EZ  O-320-E2A,  Hertzler prop, Trio AP, Narco HSI, Custom headers, Oil heat.

Offline LongEZDaveA

  • Newbie
  • *
  • Posts: 90
  • My Long EZ at Oshkosh 2008
    • View Profile
Re: Aileron control rod
« Reply #2 on: March 21, 2008, 09:07:13 AM »
Quote from: GlennBob
I read somewhere in the CP's that the heim connectors were supposed to be replaced with larger ones.  Instead of AN 3, . .they were to be AN 4's now.  Izzat true ?  Is everyone doin' it ?   Is it neccessary ?

Glennbob


It is true that the change came out in the CPs.  I'm still on the fence about the change and have not made the change.  I am interested in other's opinions.
Logged
Dave Adams, Long EZ N83DT (Race 83) Villa Ridge, MO

Offline GlennBob

  • Newbie
  • *
  • Posts: 261
  • Eph 2 : 8 & 9
    • View Profile
aileron control rod
« Reply #3 on: March 30, 2008, 10:26:10 PM »
Robert,

Do you have a set of plans ?

Glennbob
Logged
N600EZ  O-320-E2A,  Hertzler prop, Trio AP, Narco HSI, Custom headers, Oil heat.

Offline robert mencl

  • Newbie
  • *
  • Posts: 9
    • View Profile
aileron control rod
« Reply #4 on: March 31, 2008, 09:30:22 PM »
Glennbob, no, I don't have prints, but as that is the only part I am lacking, it seems unnecessary. I just need the dimension. My rotary conversion is almost done. Bob in Houston
Logged
Pages: [1]
« previous next »