Electric roll trim
« previous next »
Pages: [1]

Author Topic: Electric roll trim  (Read 3232 times)

0 Members and 1 Guest are viewing this topic.

Offline atfloyd

  • Newbie
  • *
  • Posts: 28
    • View Profile
Electric roll trim
« on: March 17, 2006, 11:09:29 AM »
Anyone have any luck with a Ray Allen servo in thier roll tim setup?  I am looking for alternatives to the plans trim system.  Thanks

Allen
Logged

Offline EZPILOT742X

  • Newbie
  • *
  • Posts: 61
    • View Profile
Electric roll trim
« Reply #1 on: March 17, 2006, 02:51:49 PM »
Hello,
Check this out on James Redmon's Berkut site.:

http://www.berkut13.com/berkut29.htm#aileron

This is a pretty typical Ray Allen/electric trim installation on an EZ-type aircraft. On my Berk-EZ I'm planning on mounting the servo in a similar fashion but using the "Wright/Hanka" spring set up. You can see a description of that on Wayne Hick's Cozy site here:

http://www.maddyhome.com/canardpages/pages/waynehicks/chapter_17_1.htm

Hope that helps,
Chris Randall
Berk-EZ N742X
Logged

Offline Hiflier68

  • Newbie
  • *
  • Posts: 51
    • View Profile
Installed
« Reply #2 on: March 20, 2006, 12:54:26 AM »
I have just finished an install of the Hanka spring. Send me an email address and I can send them over.

Mitch  hiflier68@yahoo.com
N60P
Tampa
Logged
Pages: [1]
« previous next »