Hangar Flying

Hi, all. I'm thinking about building a remote controlled 1/6 scale model of the long-ez, but it seems that every set of plans available costs a good sum of money. I do not need all of the specifications that would apply to the full scale, just the general dimensions for the outline. If anybody could fill me in on this, it would be great. Absolutely exact measurements are not needed, but within an inch or two would be best. Thanks in advance. -RPM

Wing
     span
          panel 1 (YY1)
          panel 2 (YY2)
          panel 3 (YY3)
     chord
          root (AA)
          panel 1 (BB)
          panel 2 (CC)
          tip (DD)
     sweep (Distance or degrees. Only one of these measurements is necessary)
          panel 1 (SS1)
          panel 2 (SS2)
          panel 3 (SS3)

Canard
     span (Y)
     chord (A)

Fuselage
     length
          nose to parallel middle body (L1)
          parallel middle body (L2)
          parallel middle body to aft tip (l3)
     height (H)
     width (W)

Stabilizers
     span
          upwards (YYY1)
          downwards (YYY2)
     chord
          root (AAA)
          top tip (BBB)
          bottom tip (CCC)
     sweep (Distance or degrees)
          top (SS1)
          bottom (SS2)

Control Surfaces
     canard
          span (E)
          chord (G)
          distance from tip (F)
     wing
          span (EE)
          chord (GG)
          distance from tip (FF)

Misc.
     Distance from wing root LE to canard root LE
     canopy
          length (P)
          width (Q)
          height (R)
          distance from nose (S)