Hangar Flying

Hangar Flying => Hangar Flying => Topic started by: Ghost-Rider on February 01, 2005, 11:57:14 AM

Title: Nose Gear Ratchet Crank
Post by: Ghost-Rider on February 01, 2005, 11:57:14 AM

If anyone can point me in the right direction, I am interested in plans that modify the Rutan nose gear hand crank to a ratchet hand crank.

I have seen it on two EZs’. In both cases it was purchased that way. A 3/8s ratchet is somehow incorporated into the crank mechanism.

If anyone has plans or can point me in the right direction, it would be greatly appreciated.

Title: ratchet
Post by: larry on February 01, 2005, 12:26:50 PM

try this site http://ourworld.compuserve.com/homepages/Composite_Aircraft_Accessories/nosegear.htm

Title: Nose Gear Ratchet Crank
Post by: Anonymous on February 01, 2005, 12:34:04 PM

Mine uses a standard 1/4 inch Craftmans socket ratchet.  The center of the ratchet is drilled out and the handle assembly goes through the middle, with a roll pin that secures it to the ratchet assembly.  Cut the original handle off the ratchet. reconnect the linkage, then and flox the whole thing in the panel.