Show Posts - dasha149

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dasha149

Pages: [1]
1
Hangar Flying / prop extention
« on: March 30, 2007, 03:27:12 PM »
How much it will cost me for you to ship the prop extention to Watsonville ca?


Thanks,

David

2
Hangar Flying / infinity ?
« on: June 23, 2006, 11:03:25 PM »
Hi There,

Did you end up buying the gear? if so, did you buy it from the Infinity?
How was the buying experience?

Thanks,

3
Hangar Flying / Sumps
« on: November 26, 2005, 01:27:58 PM »
I am sure I am asking a dumb question here – but here we go:
What is the reason ez drivers are using the sumps? What would happen if we will route the fuel line from the fuel tank directly to the fuel selector?

Thanks,

David

4
Hangar Flying / O-320 install question
« on: November 25, 2005, 05:55:33 PM »
Thanks Drew,

you are 10 steps ahead of me...very usfull info though.  I thoght I would use the old aluminum angels as a jig to drill the new ones - obviously the wrong idea...   D.

5
Hangar Flying / O-320 install question
« on: November 25, 2005, 03:33:55 PM »
Hello guys,

I am in the process of removing the 4 aluminum extruded angels (the ones the engine mount is bolted to) to replace with beefier ones. Any suggestions on how to reach the bolts for the screws that hold those aluminum angels without too much damage to the outside skin?

Thanks

David

6
Hangar Flying / Engine/prop question
« on: February 01, 2005, 06:10:16 PM »
Hello ez drivers, Is someone in the EZ community flying with a constatnt speed prop? I am contemplating a 320 B3B that is set up for that - would it be a mistake to go this route because of weight considerations? Thanks,  David

Pages: [1]